Norgren GT Wiper Washer Controller
FEATURES
The Norgren GT Development Wiper Washer Controller with integrated wiper delay function is designed for installation on vehicle dashboards to control wiper speed and wash functions. The microprocessor-based device combines the functions of two or three conventional wiper controls, and mounts in a standard 22mm x 44mm dashboard cutout.
The Wiper Controller has been custom designed to control all wiper functions. The multi-function toggle is used to turn the wiper on and off, and also varies wiper speed between high, low, and five intermittent speeds. The lower button initiates a combined wash and wipe cycle.
PERFORMANCE of Wiper Washer Controller
- Application – Designed for installation on vehicle dashboards to control wiper speed
- Wiper modes – High, low, mist and interval delays of 3,5,8,12,17 seconds. High and low speed wiper rate are determined by the wiper motor selection. Interval delay is achieved by a .5 second activation of the low speed wiper output (one wipe). Delay cycle is times from start to start
- Functionality – Refer to actuator motion legend table.
- Circuit Diagram – Refer to schematic
- Wash Motor – Six amps maximum current (12 volts)
- Temperature – Operating temperature = -20 Degree to 160 Degree F, storage temperature = -40 Degree to 185 Degree F
- Nominal voltage -12 volts (9 volts minimum, 16 volts maximum)
- Electrical/Environmental – Conforms to SAE J1455 (load dump, reverse polarity, over voltage, inductive switching, mutual coupling, ESD, cold cranking and radiated susceptibility).
- Relay Coil Resistance = 60 ohms (minimum) for 12 volt systems
- Mounting – Designed to mount in a 22mm x 44mm (.867 +/- 005 x 1.734 +/- .005″) dashboard opening with a panel thickness of .062″ to .094″ and .108″ to .128″
- Material – Zytel 72G13 HSIL BK Black Nylon 6/6 13% Glass
- Part Marking – Part labeled with GT part number and date code.
